Toll Free

888-208-0145
 

Canton, PA 570-673-4340

Williamsport PA 570-327-8440

CONTACT US FOR MORE INFO!

Components & How They Work

A geothermal heat pump is a heat pump that uses the Earth as either a heat source, when operating in heating mode, or a heat sink, when operating in cooling mode.

Geothermal heat pumps can be characterised as having one or two loops. The heat pump itself, explained more fully in the article on heat pumps, consists of a loop containing refrigerant. The refrigerant is pumped through a vapor-compression refrigeration cycle that moves heat from a cooler area to a warmer one.

In a single loop system, the copper tubing refrigerant loop actually leaves the heat pump appliance cabinet and goes out of the house and under the ground and directly exchanges heat with the ground before returning to the appliance. Hence the name "direct exchange" or DX. Copper loop DX systems are gaining acceptance due to their increased efficiency and lower installation costs but the volume of expensive refrigerant remains high. In a double loop system, the refrigerant loop exchanges heat with a secondary loop made of plastic pipe containing water and anti-freeze (propylene glycol, denatured alcohol or methanol). After leaving the heat exchanger, the plastic pipe goes out of the house and under the ground before returning, so the water is exchanging heat with the ground. This is known as a water-source system. In principle this need not be pressurized, so inexpensive plastic tubing could be used, but in practice the heat-exchange coil in the appliance requires pressurization to flush out air and to obtain the necessary flow.

Components

Geothermal System ComponentsGeothermal systems require a length of buried tubing on the property, a liquid pump pack and a water-source heat pump. Expansion tanks and pressure relief valves can be installed. The tubing can be installed horizontally as a loop field or vertically as a series of long U-shapes (see below). The purpose of the tubing is to transfer heat to and from the ground. The size of the loop field depends on the size of the building being conditioned. Typically, one loop (400 to 600 feet) has the capacity of one ton or 12,000 British thermal units per hour (BTU/h) or 3.5 kilowatts. An average house will range from 3 to 5 tons (10 to 18 kW) of capacity. The second component is a liquid pump pack, which sends the water through the tubing and the water-source heat pump. Lastly, the water-source heat pump is the unit that replaces the existing furnace or boiler. This is where the heat from the tubing is transferred for heating the structure. Heat pumps have the ability to capture heat at one temperature reservoir and transfer it to another temperature reservoir. Another example of a heat pump is a refrigerator; heat is removed from the refrigerator's compartments and transferred to the outside.